[Q17-Q34] Fortinet NSE 7 – Enterprise Firewall 7.2 Practice Tests 2024 Pass NSE7_EFW-7.2 with confidence!

QUESTION 17
You created a VPN community using VPN Manager on FortiManager. You also added gateways to the VPN community. Now you are trying to create firewall policies to permit traffic over the tunnel however, the VPN interfaces do not appear as available options.

QUESTION 18
Which two statements about bfd are true? (Choose two)

QUESTION 19
After enabling IPS you receive feedback about traffic being dropped.
What could be the reason?

QUESTION 20
Which, three conditions are required for two FortiGate devices to form an OSPF adjacency? (Choose three.)

QUESTION 21
You want to configure faster failure detection for BGP
Which parameter should you enable on both connected FortiGate devices?

QUESTION 22
Which two statements about the neighbor-group command are true? (Choose two.)

QUESTION 23
Exhibit.


Refer to the exhibit, which contains an ADVPN network diagram and a partial BGP con figuration Which two parameters Should you configure in config neighbor range? (Choose two.)

QUESTION 24
Refer to the exhibit, which shows a network diagram.

Which protocol should you use to configure the FortiGate cluster?

QUESTION 25
Which statement about network processor (NP) offloading is true?

QUESTION 26
You created a VPN community using VPN Manager on FortiManager. You also added gateways to the VPN community. Now you are trying to create firewall policies to permit traffic over the tunnel however, the VPN interfaces do not appear as available options.

QUESTION 27
Which FortiGate in a Security I auric sends togs to FortiAnalyzer?

QUESTION 28
Which two statements about metadata variables are true? (Choose two.)

QUESTION 29
Refer to the exhibits, which show the configurations of two address objects from the same FortiGate.

Why can you modify the Engineering address object, but not the Finance address object?

QUESTION 30
Exhibit.

Refer to the exhibit, which provides information on BGP neighbors.
Which can you conclude from this command output?

QUESTION 31
Refer to the exhibit, which shows an error in system fortiguard configuration.

What is the reason you cannot set the protocol to udp in config system fortiguard?

QUESTION 32
Exhibit.

Refer to the exhibit, which contains a CLI script configuration on fortiManager. An administrator configured the CLI script on FortiManager rut the script tailed to apply any changes to the managed device after being executed.
What are two reasons why the script did not make any changes to the managed device? (Choose two)

QUESTION 33
Which two statements about the Security fabric are true? (Choose two.)

QUESTION 34
Exhibit.

Refer to the exhibit, which contains the partial ADVPN configuration of a spoke.
Which two parameters must you configure on the corresponding single hub? (Choose two.)