[Aug-2022] Verified H35-211_V2.5 dumps Q&As – H35-211_V2.5 dumps with Correct Answers [Q38-Q59]

NO.38 Under the H.248 protocol, if the signaling IP and media IP are both 10. 1 1 100/8, voice gateway is 10. 1 1 1.
When configuring voIP service, the following command is incorrect

NO.39 The total downstream bandwidth of the 10G EPON PONI port is the sum of the EPON downstream bandwidth
and the 10G EPON downstream bandwidth.

NO.40 (Radio) When using the siP protocol, you need to use a local number graph for matching, if you use the default
matching mode to match a 7-digit number beginning with 7727, then the following options are available?
The figure is

NO.41 The scope of protection of the (multiple choice) GPON Type B dual attribution protection includes

NO.42 (Single choice) The following statement about ssH connection is incorrect, yes

NO.43 (Multi-select) Network Management U2000 adds line templates to realize the mapping of user traffic flows to
GEM PORTS, including mapping modes(Radio)

NO.44 Under IGMP snooping, there are two users on demand under the OLT- the same program, and the olt sends
two join messages to the multicast router

NO.45 (Single choice) The following statement about the PITP protocol is incorrect

NO.46 The (radio) device periodically sends and receives LMCP packets to avoid information loss, and if packets are
not received during ( ) LACp packet interaction cycles, the system considers the port to be down

NO.47 (Single choice) The following statement about defense MAC Spoofing is wrong

NO.48 (Radio) To improve link reliability, the LT device passes through two upstream ports 0/19/0 and 0/20/0
Configure the Timedelay protection group, which of the following commands is optional

NO.49 The (radio) 10G GPON system uses XGEN frames to encapsulate data, and the PORT ID is defined in the
XGEN header as () bits.

NO.50 (Radio) In the ACL, if you need to filter the packet according to the source IP address information, destination
IP address information, port number and other information of the packet, then the acl number template created
is

NO.51 (Multiple select) When there is a backbone fiber break or OLT does not detect the expected optical signal
(L0S) alarm, the possible cause is that

NO.52 The maximum spectroscopic ratio supported by 10G GPON is (Radio) ?

NO.53 When the Type C dual home protection linkage uplink detection, if the OLT or OLT uplink fails, the Type C
dual home protection can be reversed to another OLT

NO.54 (Radio) When the 0LT global or VLAN service template enables the PITP switch, the service port allows the
upstream packet to be carried, the Vendor tag switch, and the user to carry the vendor upstream packet In the
case of tarf information, the following statement regarding olts to PITP message processing strategies is
correct

NO.55 The complete SIP message interaction process will contain multiple request and response messages, and the
sIP message header field can be used to describe what the specific solution corresponding to the current
response message is

NO.56 (Single choice) When planning qos, it is necessary to plan reasonably according to the business, and adopt the
() scheduling mode for high-priority businesses.

NO.57 (Multiple choice) Which of the following measures can be adopted by GPON in terms of traffic control

NO.58 (Single)When deploying home and guest services in a PON system, which of the following services has the
highest priority?

NO.59 When ont fails or the hardware needs to be replaced, the ONT service needs to be replaced, and then the ONT
service needs to be removed on the OLT, and then the new ONT service needs to be registered