[Q41-Q57] NACE-CIP1-001 Certification – The Ultimate Guide [Updated 2022]

NO.41 Which is a component that supplies most of the features and functions of the material?

NO.42 NACE No. 4/SSPC-SP-7 is a joint standard for

NO.43 You are the NACE Inspector on a tank lining project where a 50% solids epoxy tank lining is being applied. After application of the 19 coat you notice small blisters in some areas of the applied lining.
Your FIRST preferred course of action is to:

NO.44 A magnetic pull-off type gauge is a good choice when:

NO.45 Prior to using Inspection Tools the inspector must:

NO.46 Polymerization is the process of:

NO.47 Whenever dissimilar metals must join, the most common practice is to

NO.48 Non Conformance Reports are completed by the Inspector:

NO.49 If the project specification DOES NOT state the specific DFT measurement standards, the inspector should use

NO.50 According to SSPC PA 2 a Spot Measurement is:

NO.51 Excess moisture during holiday testing can cause erroneous indications by creating a path across the surface of the coating to pinholes previously detected, or directly to the signal return connection.
This is often referred to as:

NO.52 When holiday testing is required the Inspector is always required to enforce NACE SP 0188:

NO.53 You ate the NACE Inspector on a job where NACE No. 2/SSPC – SP 10 has been specified. You are finding the Contractor is leaving mill scale on the on surface and as a result you have been rejecting the blast. The Contractor is very upset and has told you that the standard permits up to 5% of the mill scale to remain and still be in be in compliance with the standard.
Your FIRST preferred course of action is to:

NO.54 Due to a previous premature coating failure the owner has required the original coating applicator to return to remove and replace 10,000 square feet of a failed three coat system at the applicator’s cost. Due to the financial implications of another failure, the owner has offered you the job as the NACE CIP Level 1 Coating Inspector and explained that he expects you to be his “insurance policy” for this job. You have never been involved in a warranty job before and are unfamiliar with the coating system.
Your preferred FIRST course of action is to:

NO.55 On a blast-cleaned surface, Ian ultraviolet light is generally used to detect

NO.56 ISO SA 3 is directly equivalent to:

NO.57 Stripe coats are best applied by: