Cisco 350-501 Practice Test Pdf Exam Material [Q170-Q193]

NEW QUESTION 170
What is a role of NSO?

It resides on a hypervisor that runs the Windows OS

It automates the deployment of access points with its built-in wireless LAN controller

It manages WAN infrastructure using a virtual switch

It provides full lifecycle management of a device

NEW QUESTION 171
Refer to the exhibit. An engineer is reviewing the BGP configuration.
Which router must be advertised to 10.10.10.1?

Local routes are permitted, and routes from other ASNs are denied.

All routes whether local or from other ASNs are denied.

Local routes are denied, and routes from other ASNs are permitted.

All routes whether local or from other ASNs are permitted.

NEW QUESTION 172
Refer to the exhibit. An organization s network recently experienced several significant outages due to device failures. The network administrator just moved the network devices to a new central data center, and packets are switched using labels. The administrator Is now implementing NSF on the network to reduce potential risk factors in the event of another outage. Which task must the administrator perform on each router as part of the process?

Remove route filtering to speed repopulation of the link-state database

Copy the router s existing state information and share the file with its peers to enable BGP soft resets

Implement MPLS to forward packets while the RIB updates after a faliover.

Implement Graceful Restart to mitigate the delay in MPLS LDP synchronization when the IGP starts up.

NEW QUESTION 173
Refer to the exhibit.

Router R1 is reporting that its BGP neighbor adjacency to router R2 is down, but its state is Active as shown.
Which configuration must be applied to routers R1 and R2 to fix the problem?
A)

B)

C)

D)

Option A

Option B

Option C

Option D

NEW QUESTION 174
Refer to the exhibit:

Assume all other configurations are correct and the network is otherwise operating normally. Which conclusion can you draw about the neighbor relationship between routers R1 and R2?

The neighbor relationship will be up only if the two devices have activated the correct neighbor relationships under the IPv4 address family

The neighbor relationship is down because R1 believes R2 is in AS 65012.

The neighbor relationship is up

The neighbor relationship is down because the loco I-as value for R2 is missing in the R1 neighbor statement

NEW QUESTION 175
Refer to the exhibit:

Which effect of this configuration is true?

it creates a pseudowire class named Cisco

It enables tagging for VLAN 12 on the interface

It enables MPLS on the interface

It enables AToM on interface gigabitethemet1/0

NEW QUESTION 176
What is a role of NSO?

It automates the deployment of access points with its built-in wireless LAN controller.

It manages WAN infrastructure using a virtual switch.

It provides full lifecycle management of a device.

It resides on a hypervisor that runs the Windows OS.

NEW QUESTION 177
Refer to the exhibit:

Which effect of this configuration is true?

The two routers fail to form a neighbor relationship because their system IDs are different.

The two routers successfully form a neighbor relationship

The two routers fail to form a neighbor relationship because the authentication configuration is missing

The two routers fail to form a neighbor relationship because they have different ISIS area types.

NEW QUESTION 178
Drag and drop the functionalities from the left onto the correct target fields on the right.

NEW QUESTION 179
Drag and Drop Question
Drag and drop the functions from the left onto the correct Path Computation Element Protocol roles on the right.

NEW QUESTION 180
Refer to the exhibit.

Refer to the exhibit. Router BRDR-1 is configured to receive the 0.0.0.0/0 and 172.17.1.0/24 network via BGP and advertise then into OSPF area 0. An engineer has noticed that the OSPF domain is receiving only the 172.17.1.0/24 route and default router 0.0.0.0/0 is still missing. Which configuration must an engineer apply to resolve this problem?

Option A

Option B

Option C

Option D

NEW QUESTION 181
Which utility can you use to locate MPLS faults?

MPLS LSP ping

QoS

MPLS traceroute

EEM

NEW QUESTION 182
How does Cisco DNA Center enhance network automation?

It allows network administrators to quickly deploy Cisco Layer 2 devices without requiring STP and broadcast transport.

It allows network administrators to reduce inconsistencies when they deploy and validate network configurations.

It allows network administrators to reduce the number of VRFs in a multi customer environment by automatically implementing a single VLAN per customer.

It allows network administrators to combine voice and data networks into a single topology without manual configuration.

NEW QUESTION 183
An network engineer is deploying VRF on ASBR router R1. The interface must have connectivity over an MPLS VPN inter-AS Option AB network. Which configuration must the engineer apply on the router to accomplish this task?
A)

B)

C)

D)

Option A

Option B

Option C

Option D

NEW QUESTION 184
A network engineer must collect traffic statistics for an internal LAN toward the internet The sample must include the source and destination IP addresses, the destination ports, the total number of bytes from each flow using a 64-bit counter, and all transport flag information. Because of CPU limits, the flow collector processes samples that are a maximum of 20 seconds long. Which two configurations must the network engineer apply to the router? (Choose two.)

Option A

Option B

Option C

Option D

Option E

NEW QUESTION 185
Which type of attack is a protocol attack?

HTTP flood

TFTP flood

SYN flood

Slowloris

NEW QUESTION 186
What Is the primary role of Ansible In a network?

It is used as a debugging tool for connectivity issues between the DMZ and an enterprise intranet.

It Is used to diagnose Layer 11ssues In data centers that span more than one city block.

It is used to deploy IPv6 configuration is networks That are dual slack.

It is used as a network automation provisioning and configuration tool.

NEW QUESTION 187
What is a characteristic of MVPN?

It bypasses the use of MPLS in the service provider core and transmits packets using IP only.

It uses pseudowires to route unicast and broadcast traffic over either a service provider MPLS or IP core.

It allows VRF traffic to use the service provider MPLS VPN to route multicast traffic.

It creates GRE tunnels to route multicast traffic over a service provider IP core.

NEW QUESTION 188
Drag and drop the NAT64 descriptions from the left onto the correct NAT64 types on the right.

NEW QUESTION 189
Refer to the exhibit.

An engineer is securing a customer’s network. Which command completes this configuration and the engineer must use to prevent a DoS attack?

neighbor ebgp-multihop

ebgp-multihop

tti-security

neighbor-tti-security

NEW QUESTION 190
A company needs to improve the use of the network resources that is used to deploy internet access service to customers on separate backbone and internet access network.
Which two major design models should be used to configure MPLS L3VPNs and internet service in the same MPLS backbone? (Choose two.)

carriage of full Internet routes in a VPN. in the case of Internet access VPNs

Internet routing through global routing on a PE router

Internet access routing as another VPN in the ISP network

Internet access through leaking of Internet routes from the global table into the L3VPN VRF.

Internet access for global routing via a separate interface in a VRF

NEW QUESTION 191
Refer to the exhibit:

Router 1 was experiencing a DDoS attack that was traced to interface gjgabitethernet0/1.
Which statement about this configuration is true?

Router 1 drops all traffic that ingresses interface gigabitethernet0/1 that has a FIB entry that exits a different interface

Router 1 accepts source addresses on interface gigabitethemet0/1 that are private addresses

Router 1 accepts all traffic that ingresses and egresses interface gigabitethernet0/1

Router 1 accepts source addresses that have a match in the FIB that indicates it is reachable through a real interface

NEW QUESTION 192
A network administrator must monitor network usage to provide optimal performance to the network end users when the network is under heavy load. The administrator asked the engineer to install a new server to receive SNMP traps at destination 192.168.1.2. Which configuration must the engineer apply so that all traps are sent to the new server?

snmp-server enable traps entity
snmp-server host 192.168.1.2 public

snmp-server enable traps bgp
snmp-server host 192.168.1.2 public

snmp-server enable traps isdn
snmp-server host 192.168.1.2 public

snmp-server enable traps
snmp-server host 192.168.1.2 public

NEW QUESTION 193
Refer to the exhibit:

If router RA is configured as shown, which IPv4 multicast address space does it use?

224.0. 0.0/8

225.0. 0.0/8

232.0. 0.0/8

239.0. 0.0/8

Be the first to reply

Leave a Reply Cancel reply