Online JN0-649 Test Brain Dump Question and Test Engine [Q10-Q31]

QUESTION 10
Which three configuration parameters must match on all switches within the same MSTP region? (Choose three.)

QUESTION 11
You must provide network connectivity to hosts that fail authentication. In this scenario, what would be used in a network secured with 802.1X to satisfy this requirement?

QUESTION 12
You are troubleshooting a BGP connection.
Referring to the exhibit, which two statements are correct? (Choose two.)

QUESTION 13
Which two statements are correct about the deployment of EVPN-VXLAN on QFX Series devices? (Choose two.)

QUESTION 14
Referring to the exhibit, which LSA type is used to advertise 192.168.1.0/24 to R5?

QUESTION 15
Referring to the exhibit, which two statements are correct? (Choose two.)

QUESTION 16
Referring to the exhibit, a PIM-SM network is set up to enable communication between multicast devices.
Which two statements are true? (Choose two.)

QUESTION 17
You are asked to implement fault tolerant RPs in your multicast network. Which two solutions would accomplish this behavior? (Choose two.)

QUESTION 18
You are asked to configure 802.1X on your access ports to allow only a single device to authenticate.
In this scenario, which configuration would you use?

QUESTION 19
You have PIM SM multicast configure and running in a network environment comprised of EX4300 devices. Your customer report increased delay when switching channels using IPTV. To help decrease the delay, you implement PIM join balancing. You add the set protocol pim join- load-balance command to the configuration. After committing, you notice that the flows are still using one path.
In this scenario, which statement is correct?

QUESTION 20
A customer on MSTI-2 was isolated due to a physical link outage on Switch 5’s ge-0/0/32 interface.

Referring to the exhibit, which corrective action would solve this problem?

QUESTION 21
BGP multipath or multihop are not configured in your network. In this scenario, what is the correct sequence for BGP active route selection?

QUESTION 22
What allows non-Web enabled devices to access the network on a port configured for captive portal?

QUESTION 23
Click the Exhibit.

Switch 4 is rebooted as shown in the exhibit.
Which statement is correct in this scenario?

QUESTION 24
You want to create an OSPF area that only contains intra-area route information in the form of Type 1 and Type 2 LSAs.
In this scenario, which area is needed to accomplish this task?

QUESTION 25
Which protocol is used for port-level access control and authentication?

QUESTION 26
Your enterprise network is running BGP VPNs to support multitenancy. Some of the devices with which you peer BGP do not support the VPN NLRI. You must ensure that you do not send BGP VPN routes to the remote peer.
Which two configuration steps will satisfy this requirement? (Choose two.)

QUESTION 27
Referring to the exhibit, you have placed the cos multifield classifier on all edge interfaces and configured the relevant CoS parameters.
In this scenario, which two statements are correct? (Choose two.)

QUESTION 28
You are 802.1X supplicant, but traffic must be accepted once the user has authenticated their computer on the port In this scenario, which supplicant mode should be used?

QUESTION 29
You are implementing a single spanning tree instance in your network and want to use the protocol that will give you the best convergence time in the event of a physical network failure of the root bridge. Which spanning tree protocol will satisfy this requirement?

QUESTION 30
You are adding VNI 101 to your EVPN-VXLAN network, but traffic is not being sent to received.
Referring to the exhibit, which configuration statement will solve the problem?

QUESTION 31
Referring to the exhibit, on which three IS-IS routers will the attached bit be set? (Choose three.)