APICS Certification CPIM Dumps Full Questions with Free PDF Questions to Pass [Q311-Q328]

NEW QUESTION 311
The process capability index combines:

NEW QUESTION 312
Master production schedule, inventory records and bills of material are three major inputs to

NEW QUESTION 313
As applied to inventories, it is usually found that the relationship between the percentage of items and the percentage of annual dollar usage follows a pattern in which three groups can be defined:
Group A About 50 % of the items account for about 5 % of the dollar usage Group B About 20 % of the items account for about 80 % of the dollar usage Group C About 30 % of the items account for about 15 % of the dollar usage

NEW QUESTION 314
The time normally required to produce an item in a typical lot quantity is known as:

NEW QUESTION 315
Which cost would be the interest lost by not investing the money at the prevailing interest rate, and it may be much higher depending on investment opportunities for the firm?

NEW QUESTION 316
A tracking signal can be used to monitor the quality of forecast.

NEW QUESTION 317
The bill of material shows

NEW QUESTION 318
A scheduled receipt is an order that has been issued:

NEW QUESTION 319
If company uses other companies or individuals to distribute some or all of its products to the final consumer, these companies or individuals are called:

NEW QUESTION 320
The consolidation of several units into large units, called unit loads, so there is less handling, this is referred to as:

NEW QUESTION 321
This figure shows that:

NEW QUESTION 322
A systematic, formal, and conscious procedure for testing to determine customer opinion or intention is called:

NEW QUESTION 323
Which scheduling is concerned with production activity from the present to a few months ahead?

NEW QUESTION 324
What the following figure shows:

NEW QUESTION 325
The line between two or more supply sources where the laid-down cost is the same is known as:

NEW QUESTION 326
Dependency in MRP can be

NEW QUESTION 327
Toyota has designed seven important sources of waste in manufacturing. The first four relate to the design of the manufacturing system and the last there to the operation and management of the system. Which one of the following is NOT out of those sources of waste?

NEW QUESTION 328
For back scheduling we need to know?