Latest Success Metrics For Actual JN0-351 Exam 2026 Realistic Dumps [Q81-Q103]

Rate this post

Latest Success Metrics For Actual JN0-351 Exam 2026 Realistic Dumps

Updated JN0-351 Dumps Questions For Juniper Exam

NEW QUESTION 81
Referring to the exhibit, which two configuration changes must you apply for packets to reach from R1 to R3 using IS-IS? (Choose two.)

On R1, enable Level 1 on the ge-0/0/1 interface.

On R3 disable Level 2 on the ge-0/0/4 interface.

On R1, disable Level 2 on the ge-0/0/1 interface.

On R3 enable Level 1 on the ge-0/0/4 interface

NEW QUESTION 82
Which two statements are correct about IS-IS? (Choose two.)

IS-IS uses IPv6 as its transport protocol in the Junos OS Implementation.

IS-IS has two metric types and Junos sends both by default.

IS-IS sends a maximum metric value of 63 by default.

IS-IS only allows you to configure two areas.

NEW QUESTION 83
Referring to the output shown in the exhibit, which two statements are true?

The route is active

The route is not active

The route is a generate route

The route is an aggregate route

NEW QUESTION 84
Which two statements are correct about using firewall filters on EX Series switches? (Choose two.)

You can deploy only stateless firewall filters on an EX Series switch.

You can only apply firewall filters to Layer 2 traffic on an EX Series switch.

You can apply firewall filters to both Layer 2 and Layer 3 traffic on an EX Series switch.

You can deploy both stateless and stateful firewall filters on an EX Series switch.

NEW QUESTION 85
Exhibit

What does the * indicate in the output shown in the exhibit?

The switch ports have a router attached.

The interface is down.

The interface is active.

All interfaces have elected a root bridge.

NEW QUESTION 86
Which two types of tunnels are able to be created on all Junos devices? (Choose two.)

STP

GRE

IP-IP

IPsec

NEW QUESTION 87
Which two statements are correct about Junos OS Nonstop Active Routing (NSR)? (Choose two.)

NSR requires graceful restart to be enabled on neighboring routers.

NSR maintains routing protocol state synchronization between the master and backup Routing Engines.

NSR allows a Routing Engine switchover to occur without neighboring routers detecting any disruption.

NSR is only supported for static routing.

NEW QUESTION 88
Which statement is correct about the configuration shown in the exhibit?

The configuration will not complete the commit check process and will error out.

The ge-0/0/0 and ge-0/0/1 interfaces are operating in trunk mode.

All three interfaces are operating in access mode.

The ge-0/0/2 interface is operating as a Layer 3 interface.

NEW QUESTION 89
Referring to the exhibit, Router-1 and Router-2 are failing to form an IS-IS adjacency.

What should you do to solve the problem?

Remove the overloaded statement from Router-1.

Change the IP subnet masks to match on the ge-0/0/2 interfaces of both routers.

Change the ISO areas on the lo0 interfaces to match on both routers.

Remove the ISO address from ge-0/0/2 on Router-1.

NEW QUESTION 90
Exhibit.

You are using OSPF to advertise the subnets that are used by the Denver and Dallas offices. The routers that are directly connected to the Dallas and Denver subnets are not advertising the connected subnets.
Referring to the exhibit, which two statements are correct? (Choose two.)

Create static routes on the switches using the local vMX router’s loopback interface for the next hop.

Configure and apply a routing policy that redistributes the Dallas and Denver subnets using Type 5 LSAs.

Configure and apply a routing policy that redistributes the connected Dallas and Denver subnets.

Enable the passive option on the OSPF interfaces that are connected to the Dallas and Denver subnets.

NEW QUESTION 91
Referring to the output shown in the exhibit, which statement is correct?

The state is normal for a DR neighbor.

The state is normal for a DRother neighbor

An MTU mismatch exists between the OSPF neighbors.

An area ID mismatch exists between the OSPF neighbors

NEW QUESTION 92
You are troubleshooting a BGP routing issue between your network and a customer router and are reviewing the BGP routing policies. Which two statements are correct in this scenario? (Choose two.)

Export policies are applied to routes in the RIB-ln table.

Import policies are applied to routes in the RIB-Local table.

Import policies are applied after the RIB-ln table.

Export policies are applied after the RIB-Local table.

NEW QUESTION 93
Which two statements about redundant trunk groups on EX Series switches are correct? (Choose two.)

Redundant trunk groups use spanning tree to provide loop-free redundant uplinks.

Redundant trunk groups load balance traffic across two designated uplink interfaces.

Layer 2 control traffic is permitted on the secondary link.

If the active link fails, then the secondary link automatically takes over.

NEW QUESTION 94
A host is connected to your EX Series switch using an interface with persistent MAC learning enabled. When you connect the host to another interface on the same switch, all traffic generated by the host is dropped.
Which action should you perform to solve the problem?

Disable dynamic ARP inspection.

Enter the clear Ethernet switching table persistent learning command.

Enter the clear dhcp snooping database command.

Configure the Interface as a trunk port.

NEW QUESTION 95
Which statement is correct about IP-IP tunnels?

IP-IP tunnels only support encapsulating IP traffic.

IP-IP tunnels only support encapsulating non-IP traffic.

The TTL in the inner packet is decremented during transit to the tunnel endpoint.

There are 24 bytes of overhead with IP-IP encapsulation.

NEW QUESTION 96
You are asked to connect an IP phone and a user computer using the same interface on an EX Series switch.
The traffic from the computer does not use a VLAN tag, whereas the traffic from the IP phone uses a VLAN tag.
Which feature enables the interface to receive both types of traffic?

voice VLAN

native VLAN

MAC limiting

DHCP snooping

NEW QUESTION 97
You are using tunnels in your network. It is important that the routes be specific enough to ensure that the tunnels are established. You need to prevent a route that is new to the network from being used. In this scenario, which type of route should be used?

multicast

aggregate

static

anycast

NEW QUESTION 98
You have DHCP snooping enabled but no entries are automatically created in the snooping database for an interface on your EX Series switch. What are two reasons for the problem?
(Choose two.)

The device that is connected to the interface has performed a DHCPRELEASE.

MAC limiting is enabled on the interface.

The device that is connected to the interface has a static IP address.

Dynamic ARP inspection is enabled on the interface.

NEW QUESTION 99
Which two statements are true about high availability on Junos devices? (Choose two.)

BFD is faster at detecting failures than default GRE or OSPF timers.

BFD is slower at detecting failures than default GRE or OSPF timers.

NSR is dependent on helper routers to assist the routing platform in restoring routing protocol information.

NSR is independent of helper routers to assist the routing platform in restoring routing protocol information.

NEW QUESTION 100
Which two BGP attributes must be supported by all BGP implementations and must be included in every update? (Choose two.)

AS path

MED

next hop

community

NEW QUESTION 101
Exhibit

You are receiving the BGP route shown in the exhibit from four different upstream ISPs.
Referring to the exhibit, which ISP will be selected as the active path?

ISP1

ISP 3

ISP 4

ISP 2

NEW QUESTION 102
You are asked to configure a redundant trunk group (RTG). Which two requirements would accomplish this task? (Choose two.)

The RTG must be participating in a Spanning Tree topology.

Interfaces within an RTG can be configured as access ports.

Interfaces within an RTG must be configured as trunk ports.

Both interfaces of an RTG must be configured to service the same VLANS.

NEW QUESTION 103
Which two statements are correct about Junos OS static route configuration with a “qualified- next-hop”? (Choose two.)

A qualified next hop allows a different preference value to be assigned to specific next hops of the same static route.

Qualified next hops are used to implement floating static routes for backup connectivity.

Qualified next hops require BGP to be configured.

A static route can only have a single next hop when using qualified-next-hop.

Juniper JN0-351 Exam Syllabus Topics:

Topic	Details
Topic 1	Layer 2 Security: This topic introduces Layer 2 protection mechanisms and firewall filters to fortify network security. Practical skills in configuring, monitoring, and troubleshooting these features prepare candidates to address exam objectives and real-world challenges effectively.
Topic 2	Layer 2 Switching or VLANs: This topic deepens the understanding of Layer 2 switching operations within the Junos OS, including VLAN concepts and benefits. Experienced networking professionals gain insights into configuration, monitoring, and troubleshooting techniques essential for network segmentation and efficiency.
Topic 3	High Availability: This topic covers the importance and application of high availability within Junos OS environments. Knowledge in configuring and managing these components is critical for ensuring robust and uninterrupted network operations, aligning with exam expectations.
Topic 4	BGP: This topic focuses on the operational and conceptual elements of BGP, a cornerstone in enterprise networks.

Full JN0-351 Practice Test and 192 Unique Questions, Get it Now!: https://www.actualtorrent.com/JN0-351-questions-answers.html

Latest Success Metrics For Actual JN0-351 Exam 2026 Realistic Dumps [Q81-Q103]

Juniper JN0-351 Exam Syllabus Topics:

Be the first to reply

Leave a Reply Cancel reply

Juniper JN0-351 Exam Syllabus Topics: