Latest DES-DD23 Pass Guaranteed Exam Dumps with Accurate & Updated Questions [Q10-Q26]

Q10. When using the DD VTL Tape Out to Cloud feature, which status will a tape show once it is in the cloud tier vault?

Offsite

Offline

Archived

Vaulted

Q11. An engineer is configuring a PowerProtect DD system for VTL using Fibre Channel. How should the zones be configured?

Hard zones

Single initiator, multi target

Single initiator, single target

Soft zones

Q12. What is the order of steps to configure DD Boost on a PowerProtect DD appliance?

Q13. What happens to the data when it is moved from the active tier to cloud tier?

It is deduplicated and stored in object storage the native format

It is compressed and stored as object storage in a new format

It is compressed and stored in block storage in a new format

It is deduplicated and stored in a file system in the native format

Q14. Which command is used to start the initial CLI configuration wizard?

config setup

install config

config

setup

Q15. An administrator is migrating their old cloud tier-enabled Data Domain to a new PowerProtect DD appliance with cloud tier. During migration, the administrator recognizes that file system cleaning on the source system is not possible.
What is the most likely cause of this behavior?

Migration will restrict all activities on source systems.

Migration will restrict all activities on both systems.

Filesystem is disabled on source system.

Source system is running in restricted mode.

Q16. What is a requirement to use the PowerProtect DD HA feature?

Each head unit requires its own FS25 shelf

Head units and nodes require an active/active configuration

A single set of shared storage

Dual set of shared storage configuration

Q17. What is the maximum capacity for a DDVE?

64 TB

96 TB

128 TB

256 TB

Q18. Which command is used to check if NFS is enabled?

nfs enable

nfs status

nfs show clients

system show

Q19. What is the order of steps to configure DD Boost on the backup host?

Q20. What is the correct sequence of steps to configure storage for Dell EMC Cloud Tier in the DD System Manager?

Q21. Refer to the exhibit.

Match each action to its call-out location.

Q22. An organization uses tape libraries in their current backup infrastructure. They have purchased a PowerProtect DD system and plan to use VTL to move from physical tape.
What is a consideration when configuring the tape size?

Use multiple drives to write multiple streams

Set retention periods for as long as possible

Target multiple drives to write single stream

Use larger tapes for multiple smaller datasets

Q23. What is the order of steps to configure DD Boost on a PowerProtect DD appliance?

Q24. Refer to the exhibit.

To which shelf and port should SAS HBA slot 1 port B be connected?

Shelf 04 BH

Shelf 01 BH

Shelf 04 BE

Shelf 01 BE

Q25. Which component executes the read/write requests in a backup environment consisting of a PowerProtect DD appliance and IBM Spectrum Protect?

Spectrum Protect Server

Media Server

Media Agent

Master Server

Q26. A backup administrator has enabled the Retention Lock feature on their PowerProtect DD appliance. Over time, the administrator noticed an increase in file system utilization. Upon further investigation, the administrator discovered expired files are still present on the appliance.
What is the most likely reason for this issue?

The time of the file was set below the minimum retention period

Retention Lock feature was disabled before the expiration date

File system cleaning was disabled

Backup application failed to delete the file after expiration

Latest DES-DD23 Pass Guaranteed Exam Dumps with Accurate & Updated Questions [Q10-Q26]

Be the first to reply

Leave a Reply Cancel reply